Roofing felt is a special material with good weather proofing features, which is why it has been a popular material used by the roofing specialists for years. The most widely recognized size for roofing felt is 36-inches wide and are reputed to be the 15 pound paper. There are also some rolls of roofing felt that are premarked to help you with the felt roofing installation.
The papers have markings in them so you can position the strips straight to the roof. Afterwards, you must trickle the edge on the eaves and the flashing as well as the valley liner should all be installed right before you put the roofing felt. The process of installation is not that easy, so you better ask with some elastic roofing contractors that could have the ability to do the installation for you. Youtube video on Roofing Company San Antonio now available, check it asap!
Setting up the Decking
When you start with the felt roofing installation, you should make a point to clean the decking admirably. It must be free from any debris and moisture and in case you perceive that some of the decking has moisture and harm in them, you should swap them immediately. Make a point to inspect the whole deck and see if there are any nails in them.
There are those instances when the nails won’t turn out on top of the material when the old roofing material is evacuated from the deck. It is also an exceptional thought to run a flathead shovel on the deck just to make certain if all the nails were evacuated fully. As soon as the decking is all set, make a 33 5/8-inches chalk line above the eave line. This allows a 3/8-inch overhand on the first strip of the roofing felt. Afterwards snap the rest of the lines in every 34-inch going up towards the roof. Visit here to learn more about roofing.
Installation
Start the installation on the edge of the eave and move from rake to rake. Afterwards, track the paper down towards the core and verify that you keep it from tumbling from the roof. Next, cut the paper flush on the rake using utility cut with a specific end goal to adjust the chalk line you made.
As soon as you are carried out adjusting it, nail the felt with roofing nails or simply staple them set up after every 3 – 4 inches. Rehash the process again while going up towards the roof until you in the end achieve the edge of the roof. When you require more consultation on this, check with some elastic roofing contractors in your general vicinity. See more details about Roofing Company in San Antonio here http://www.roofingcompanysanantonio.co/.
Article Written by James Murphy
322 Redwood St
San Antonio, TX
78209
(210) 598 – 5009